A general purpose, non thixotropic resin for casting which will accept higher filler loadings than the general purpose resin. It has reduced exotherm and improved degassing. Activate with catalyst at 2% by weight. Colour with pigment paste. | A water clear casting resin for embedding and casting paperweights,specimens etc. Pot life at 20 ºC using 2%catalyst is approx.20 minutes.To help prevent cracking use 1%catalyst and place in water bath. | A low odour two component polyurethane system which is designed for thin sections, or castings up to 20mm thick that require very quick demould times and can be used unfilled.Good thermal resistance. With low viscosity it produces excellent surface detail and finish. Does not shatter like polyester casts. Simulates polypropylene when fully cured. |
This is a specially formulated polyester resin for mouldmaking.This product has nil shrinkage which enables moulds 20mm thick to be made in just one day without any distortion.Pack includes catalyst | This well known high performance isophthalic resin is used for surfboard manufacture with excellent clarity. UV stable. | An isothallic resin used where better resistance against heat and chemicals is required. To obtain full properties the finished laminate should be "post cured" for at least 3hrs at 80degC. For chemical tanks check resin suitability. A resin/tissue coating will also improve resistance. Pot life at 20degC. using 2% catalyst is approximately 35 minutes. |
A top quality general purpose resin. For laminates requiring fire retardancy to BS476. | This resin is a bisphenol A epoxy based vinylester which offers chemical resistance towards acids, alkalines and oxidizing agents. High heat distortion temperature (100c) and excellent bonding makes this resin far superior to polyester resins. | |
Goto Top
RSS